Open front sight post assembly for Hi-Point 995TS, 3895TS, 4095TS, 4595TS & 1095TS Rifles

• Precision CNC machined from mild steel with durable Black Manganese Phosphate coating
• Absolute co-witnessing on EOtech XPS2/3 or equivalent or lower 1/3 co-witness with EOtech EXPS2/3 or equivalent when mounted on our aluminum replacement rails or factory (OEM) rail. Sight base may be adjusted approximately +/- 4 mm to compensate for different rear sight and rail geometries.
• Compatible with 995TS, 3895TS, 1095TS, 4095TS & 4595TS. Simple installation and absolutely no modifications required to original firearm.
• Replaceable top sight components. Includes fully adjustable Extended National Match (A1) post. Compatible with all A1/A2 posts and adjustment tools.
• Compatible a large array of standard (1.4" / 36mm rail to aperture), readily available rear sights. Since this sight is designed to match taller rear sights, it will not adjust down far enough to work with the original OEM rear peep sight. It is only intended for use with aftermarket rear sights.

Converts front sight assembly to standard adjustable height post MSR open type sight picture. Sight base will accept a variety of A1 (five detent) & A2 (four detent) style sight posts. Includes fully adjustable Extended National Match (A1) post.

Simple installation uses factory barrel mount and retains original under barrel rail. Absolutely no modifications required to original firearm. Works with standard height (1.4" / 36mm rail to aperture) rear sights such as NC-Star BUIS, MAGPUL MBUS, etc... (See photos for some examples). The sight comes pre-assembled with blue thread-lock. The wrenches are only required if one of the assembly screws were to loosen in the future. Two button-head screws on the sides securely center the sight head in the proper side to side orientation and a front set screw expands the sight head dove-tail to lock it in place on the sight base post. Left right aim point adjustment is done on the rear sight, the front sight height may be done coarsely with the slot to used mount the base post to the base on the firearm and fine adjustment is via turning the actual A1 sight post. Includes fully assembled sight post assembly and hex wrenches for sight component repair or tightening. Other components in shown in photos illustrate installation configurations and are not included. The last two photos give a visual comparison of the open front sight to the OEM front sight

Note: Many rail mounted accessories use a Picatinny (MIL-STD-1913) compatible recoil bolt / bar that will not fit the factory (Weaver) rail without modification. We offer STANAG / Picatinny aluminum replacement rails for the 995TS / 3895TS / 1095TS / 4095TS / 4595TS, SR-HP995TS-T(E)-BLK & SR-HP4x95TS-T(E)-BLK, that accepts all MIL-STD / MSR optics and accessories.

Sight assembly weight: 58gm.

Manufactured in the Sierra foothills - USA.